2021 FORD Bronco

Location of wiring from the factory for Blind Spot Warning and Cross Traffic Alert systems is not protected. The wiring has frayed and broken due to the wiring being unprotected, loose and rubbing on the rear bumper, causing the systems to not function. This is a blatant design defect from the factory, causing two safety systems to fail. Reporting now as, to the best of my knowledge, the manufacturer has not issued a TSB or recall and dealerships have acknowledged the issue.

While driving in snowy conditions the headlights become covered with snow to the point of not illuminating enough to see. Which then makes trying to find a spot to pull over safely to wipe them becomes extremely dangerous. The snow covered lights happens quickly. Creating hazardous driving conditions. The data provided is the most recent. This happens every winter since purchasing this vehicle. I was not familiar with notifying your agency until recently.

I was driving on the highway at a speed of approximately 70 miles per hour when the Bronco driver screen gave multiple warning notices and at the same time, the accelerator would not react. Steering power was fine. I was in the second from far left lane on a six lane highway and losing speed quickly. I was able to move to the right and drift to the side of the road without incident. Once stopped, I turned the ignition off and waited a few seconds and then turned it back on again. The error messages all cleared and the Bronco accelerator reacted appropriately. I drove it straight to the dealership for inspection. They found the 210 connector was not making a good connection. They cleaned it and added electric grease and reconnected. Everything cleared and the connection was deemed good. I have not worked in the Bronco engine compartment or had work done that would have resulted in loosening the 210 connector. My understanding from the shop is that corrosion caused this connector to loosen.

The contact owns a 2021 Ford Bronco. The contact received notification of NHTSA Campaign Number: 25V455000 (FUEL SYSTEM, GASOLINE). However, the part to do the recall repair was not yet available. The contact stated that while driving at an undisclosed speed, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The failure had occurred while driving from a stop or while driving uphill. No warning lights were illuminated. The contact stated that on a separate occasion, an unknown message about the brake system was displayed on the instrument panel. The local dealer was not contacted after the most recent failure. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 40,000.

The contact owns a 2021 Ford Bronco. The contact received notification of NHTSA Campaign Number: 25V455000 (Fuel System, Gasoline); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. The VIN was not available.

rear view camera display when vehicle is in reverse will intermittently turn blue or black which renders the rear view camera useless. and at times will state camera unavailable. vehicle is a 2021 ford bronco built on june 15, 2021 at ford Michigan build plant. i have contacted ford related to this concern as i believe that the vehicle should fall under recall 23s48 for rear camera replacement, and 25s49 for module updates related to rear camera display. the vehicle year, build date, assembly plant and symptoms all fit within the parameters of recall. note that i also have a 2022 bronco that these recalls are active on for the same concerns, the concern happens 7-8 times a week for the last 4-5 months. dealership has contacted ford sssc team about getting recalls activated on this vehicle and they are given the most basic responses stating that this vehicle is not included due to "certain model year vehicles" even though the vehicle is clearly within the model years outlined in both recalls. the rear view camera intermittently not working is a safety issue as it can stop working at any time when you would be using it to reverse. thank you for your time and consideration when investigating this concen.

The contact owns a 2021 Ford Bronco. The contact received notification of NHTSA Campaign Number: 25V025000 (SUSPENSION); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

I have been getting a message that my blind spot and cross traffic alert deactivated because trailer is attached. I have never had a trailer attached but do have a trailer hitch- the dealer said Ford refuses to pay to have it fixed because the bumper to bumper warranty is out. the car has been garaged and has only 9,000 miles on it. This is a safety issue that I think they should cover as I have no blind spot or cross traffic warnings.